iZEEKER iG400 Manual Del Usuario página 13

Note:
•
The【MODE】button in the "ON" position can only change the preview mode, not the
camera's working mode.
•
If you want to change the working mode of the camera, you must operate in the setting
menu.
•
Test shot before use
To ensure that the camera works properly, please take a test shot before use.
A. Push the mode switch to the "ON" position, press【OK】to take a photo;
B. Press【MODE】once to enter the video mode, press【OK】to shoot a video;
C. Press【MODE】twice to enter playback mode, review the video and photos taken, and
check whether the camera is working properly.
•
Automatic shooting
Set the camera parameters, install it in the shooting area, and adjust the direction and
position so that the lens is aligned with the shooting range.
Push the mode switch to the "ON" position. After the camera is turned on, if there is no
operation, it will automatically have a delay time (30S/1MIN/3MIN) according to the setting.
The red PIR light indicator will flash, and then the screen will display a 15-second countdown.
After 15 seconds, the screen turns o , and the camera enters the working mode. At this
time, the camera automatically monitors and captures moving animals or people.
•
Turn o the camera
When the camera is turned o , push the mode switch from "ON" to "OFF", the camera
will turn o . After shutting down, wait about 3 seconds before turning it on again.
9
EN