Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
TURNING ON THE WATER HEATER
1. Make sure the gas type you will use is same as the type on the data plate.
2. Turn on the main gas valve, plug in the power cord (be sure the socket is well grounded), and
press the Smart Button on the bottom center of the front cover. Set temperature to 120° F.
3. Turn on the faucet, and the fan will begin working. You will hear the ignition sound after a few
seconds. The burner will ignite, and hot water will come out. If the burner is not ignited successfully,
the ignition sound will last a few seconds. If the burner still fails to ignite, turn off the faucet and wait
for 10-20 seconds, and repeat the above procedures.
For first use and/or if the water heater has not been used for a considerable period of time, the repeat
of the above procedures may be required, due to accumulated air inside the gas pipe.
SAFETY PRECAUTIONS
If there is any difficulty in understanding or following the Operating Instructions or the Care and
Cleaning section, it is recommended that a qualified person or serviceman perform the work.
• Turn off manual gas shut off valve if
water heater has been subjected to over
heating, fire, flood, physical damage or if the
gas supply fails to shut off.
• DO NOT turn on water heater unless water
and gas supplies are fully opened.
• DO NOT turn on water heater if cold water
supply shut off valve is closed.
• DO NOT allow combustible materials such as
newspaper, rags or mops to accumulate near
water heater.
POWER SURGE/NO NETWORK
If you experience a power surge or have network connectivity issues that are enabling connection to
the Eccotemp SMARTHOME App, you can manually reset the water heater to the factory settings by
following these steps below:
• Make sure your water heater is plugged in and has power to it.
• Turn on your water heater by touching the power icon on the front, the icon should illuminate to red.
• While the power icon is still red, press the icon for 15 seconds until the power icon turns blue.
• The water heater has now reset to the original factory settings. NO timer is set, NO schedule is set,
water heater is set to 118°F
• Turn on your water heater by touching the power icon on the front, the icon should illuminate to
red and you can use the water heater at it's factory preset.
32
Support: Support.Eccotemp.com
PLEASE NOTE: SHLX IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO
CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
• DO NOT store or use gasoline or other
flammable vapors and liquids, such as
adhesives or paint thinner, in vicinity of this or
any other appliance. If such flammables must
be used, open doors and windows for
ventilation, and all gas burning appliances in
the vicinity should be shut off including their
pilot lights, to avoid vapors lighting.
NOTICE: Flammable vapors can be
drawn by air currents from surrounding
areas to the water heater
Shop Online: www.Eccotemp.com
Phone: 866-356-1992
Publicidad
