Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
DRAINING THE SHLX
Smart Button
Air Relief Valve
To Hot Water
Fauctes
Pressure Relief
Valve (Supplied)
Drain
Valve
Discharge Line
(To Suitable Drain)
Below are instructions for draining water out of the water heater.
1.
Turn off the water heater manually, by using the remote or with the Eccotemp SMARTHOME App.
2.
Close the gas shut off valve(s).
3.
Close the water shut off valve.
4.
Turn the on/off switch to the OFF position and disconnect breaker at least 10 seconds after step #1.
5.
Open drain valve.
6.
Open all hot water faucets. Before proceeding to the next step, make sure that COLD water is
coming out of all hot water faucets.
7.
To put the water heater back into operation after draining, follow the steps below.
8.
Reinstall the water filter. Close the hot water outlet drain valve.
9.
Open the water shut off valve and close again after making sure that water comes out from hot
water faucets.(This step is to remove air from the water lines.)
10. Reconnect the breaker and turn the on/off switch to the ON position, fully open the gas shut off
valve and the water shut off valve.
NOTICE: The water heater may not operate unless the above procedure is followed correctly.
40
Support: Support.Eccotemp.com
6" Air Gap
PLEASE NOTE: SHLX IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO
CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
Shop Online: www.Eccotemp.com
Manual Gas Supply
Line Shut-Off Valve
Manual Gas
Appliance Shut-off
Cold Water Supply
Line Shut-Off Valve
Phone: 866-356-1992
Publicidad
