Blackstar Amplification HT-1R MK III Manual Del Propietário página 6

3. Footswitch
A latching 2-way footswitch can be connected here. The footswitch will enable the
selection of the Clean and Overdrive channels, and the two voices on each Channel.
NOTE: using a footswitch will disable the front panel channel and voice switches.
Therefore, full control via the footswitch is granted irrespective of how the amplifier
is set.
EXTERNAL SWITCHING: This can also be used by people who wish to control
the main features of the amp using an external switching device that connects via
the TRS connection of the socket.
The following external conditions will switch the channels and voices as follows:
TIP RING
Closed Closed
Closed Open
Open Closed
Open Open
4. USB
This USB-C socket is for connection to a computer via a suitable lead (not supplied).
The output will be a stereo, fully processed guitar signal complete with speaker
cabinet emulation and reverb.
WINDOWS – The Blackstar Amplification USB Audio Driver is required to work on
Windows. Please download the driver by scanning the following QR code:
or go to:
www.blackstaramps.com/audio-driver-download
MAC - No installation of Audio Drivers are required. Connect your amp directly to
your Mac to use as a plug and play audio interface.
For a guide on low latency USB recording visit:
www.blackstaramps.com/usbrecording
NOTE: Always connect the amplifier via a main USB port, often found on the rear
of the computer.
The amplifier will appear as an audio capture device within recording software.
10
CHANNEL VOICE
Clean Voice 1
Clean Voice 2
Overdrive Voice 1
Overdrive Voice 2
Technical Specification
HT-1R MK III
Power (RMS): 1 Watt
Valves: 1 x ECC82, 1 x ECC83
Weight (kg): 6
Dimensions (mm): 310 x 305 x 178
Footswitch: FS-16 and FS-22 compatible
Speaker: Custom Designed 8"
HT-1RH MK III
Power (RMS): 1 Watt
Valves: 1 x ECC82, 1 x ECC83
Weight (kg): 3.57
Dimensions (mm): 272 x 187 x 174
Footswitch: FS-16 and FS-22 compatible.
11