Singer XL-580 Manual De Instrucciones página 106

will prompt you to enter in points B and C. Follow the same
procedures for inputting points B and C.
In a case where the three points were input wrong,
and they do not form an exact right angle, the software
will show the following error message and give you an
opportunity to enter the alignment points again.
Machine Navigator Box to send design portion of data 1 to
the machine. Embroider the design.
embroidered, click on Exit in the Machine Navigator box
and the screen will prompt you to enter the information
from the data 2 area. Use the same procedure to re-hoop
the fabric, send the data 2 design to the machine and input
blinking. Embroider the data 2 design.
11. Follow the same procedure for data 3 and data 4.
100
B
C
A
B
C