Busch+Müller Briq-S E Instrucciones De Uso página 10

4. Legal requirements
Before you operate your vehicle in public traffic, you are obliged to ensure that your vehicle complies
with national and local laws and regulations, and you, as a traffic participant must abide by the traffic
regulations that apply. These can be found in the Highway Code or national equivalent, and depending
on the country, also at other sources.
5. Technical specification
Headlight dimensions: height: 50 mm | length: 44 mm | width: 64 mm | weight: 74 g | light level intensity: 60 Lux
Requirement: at least 3 W nominal power at the light connection of the drive system.
NOTE Never connect to an AC voltage source (e.g. a dynamo)!
NOTE If your e-bike is equipped with a dynamo to supply power to the lighting system you will need a
standard dynamo headlight.
6. Assembly
6.1. General assembly instructions
!
Make sure the headlight is not covered under any circumstances. Also, take care that the headlight
has been mounted and aligned as prescribed. Align the front reflector
18
3 vertically to the road.
In Germany, the prescribed mounting height for headlights
40 and 120 cm. For details, consult your national Road Traffic Regulations or contact a local bicy-
cle specialist retailer. Always make sure the headlight is mounted and aligned in a way to ensure
that oncoming traffic is not blinded.
WARNING Never mount brackets on conical components! To prevent falls, accidents and
serious injury, use only the intended mounting bracket from Busch and Müller. If unsuitable or
ill-placed brackets are used for the assembly of lights, these can lead to loosened or detaching
parts that may trap in wheels or spokes and cause serious injury.
NOTE Make sure to tighten all screws in a way to ensure the headlight
itself. This is especially important when cycling on uneven terrain.
1 and front reflectors 3 is between
1 cannot move all by
19