Publicidad
Idiomas disponibles
Idiomas disponibles
▪
DO NOT OPERATE UNIT WHILE UNDER THE INFLUENCE OF ALCOHOL OR
DRUGS.
▪
DO NOT OPERATE UNIT UNLESS DEBRIS SHIELD AND/OR GUARD IS INSTALLED
AND IN GOOD CONDITION.
▪
DO NOT ADD, REMOVE OR ALTER ANY COMPONENTS OF THIS PRODUCT. Doing
so could cause personal injury and/or damage the unit, and void the manufacturer's
warranty.
▪
DO NOT operate your unit near or around inflammable liquids or gases whether in or out
of doors. An explosion and/or fire may result.
▪
DO NOT USE ANY OTHER CUTTING ATTACHMENT. Only use our replacement parts
and accessories, which are designed specifically to enhance the performance and
maximize the safe operation of our products. Failure to do so may cause poor
performance and possible injury. Use only the stringhead supplied with this product. Do
not use any other cutting attachment. Use of such attachments will void your factory
warranty and may result in serious bodily injury.
6 PETROL SAFETY WARNINGS
WARNING: Use extra care when handling fuels. They are inflammable and
the vapours are potentially explosive. The following points must be
observed.
▪
Use only an approved container.
▪
Never remove the fuel cap or add fuel when the engine is running. Allow engine exhaust
components to cool before refuelling.
▪
Do not smoke.
▪
Never refuel the machine indoors.
▪
Never store the machine or fuel containers in places where there is a naked flame, such
as a water heater.
▪
If fuel is spilt, do not attempt to start the power source before moving the machine away
from the spillage area.
▪
Always replace and securely tighten the fuel cap after refuelling.
▪
Whenever the tank is drained, this should be done outdoors.
7 ASSEMBLY
7.1
Assembling the brush cutter (Fig. 5)
▪
Start by undoing the screw grip on the shaft of the engine unit.
▪
Push the front shaft (5) of the hedge trimmer onto the shaft of the motor unit, turn
left/light and keep pushing the front shaft until the safety lever clicks into the locking
hole.
▪
Press the cover that protects the safety lever 9 downwards and hold it down.
▪
Tighten the screw grip.
7.2
Removing the brush cutter (Fig. 6)
▪
Undo the screw grip.
Release the safety lever by pressing and pull the front shaft (5) on the hedge trimmer out of
the shaft on the motor unit.
7.3
Bike handle
▪
Loosen the handle screws and place the handle into the holder, as depicted in the main
figure.
▪
Re-tighten the screws and verify they are properly tightened.
Copyright © 2024 VARO
POWEG8013
P a g e
| 5
EN
www.varo.com
Publicidad
