Publicidad
Idiomas disponibles
Idiomas disponibles
Warning: Make sure the grip is properly mounted and check it regularly.
Parts, which are not properly mounted, represent a risk of injury.
7.4
Mounting of the protective cover (Fig. 1)
▪
Assemble protective cover as Fig. 1 illustrates, note that the bolts should be tightened.
▪
2 fixing bolts are already assembled on the protective cover. Just remove them from the
screw openings first, then place the protective cover again and attach to the aluminium
tube (5).
7.5
Trimmer mounting (Fig. 2)
▪
Put part (B) onto the output axle of part (C).
▪
Screw the spool(A) into the output axle and tighten it manually.
7.6
Cutting blade mounting (Fig. 3)
▪
Fit the upper plate (E) to the output axle.
▪
Turn the blade axle until one of the holes in the upper plate align with the hole in the
gear housing (G).
▪
Insert a lock pin in the hole (G) so that the axle is locked. Place the blade (D), low plate
(C) and plate housing (B) on the output shaft. Fit the nut (A). Use the socket spanner in
the tool kit. Hold the handle of the spanner as close to the blade guard as possible. The
nut is tightened when the spanner is turned against the direction of rotation (left-hand
thread).
Attention! During your work with the cutting device always wear work gloves
in order to avoid cutting injuries.
Attention! Use only metal cutting blades, which are not damaged or twisted.
The cutting blade may be removed in the opposite sequence.
Attention! The cutting blade's drill hole diameter must exactly match the
turntable diameter.
7.7
Assembling the debris shield (Fig. 4)
▪
Fasten the cord cutter (A) to the shield (C) with a ST3.5x12 screw as shown.
▪
Attach the shield extension (B) to the shield bottom.
7.8
Adjusting the harness
▪
On the front is an easily accessible, quick release latch.
▪
Pull out the red strap.
▪
The hip strap and one shoulder strap will be automatically released at the same time.
8 FUEL AND LUBRICATION
8.1
Fuel
Use unleaded gas mixed with 2-cycle engine oil in the ratio 40:1. It will guarantee the unit's
optimum performance.
Caution! Do not ever use pure gasoline in your unit. It could permanently
damage the engine and exclude warranty claims concerning this product.
Never use a fuel mixture, which has been stored for more than 90 days.
Copyright © 2024 VARO
POWEG8013
P a g e
| 6
EN
www.varo.com
Publicidad
