Publicidad
Idiomas disponibles
Idiomas disponibles
Caution! Use only first class 2-cycle oil mixed in the ratio 40:1. Do not use 2-
cycle oil with the recommended mixing ratio 100:1. In case of damage caused
by insufficient lubrication no warranty claims will be possible.
8.1.1
Mixture of gasoline and oil in the ratio 40:1
First of all, pour oil into the mixing bottle and then add gasoline in order to mix it with the oil.
Shake the bottle properly in order to reach a good mixture.
Caution! Insufficient lubrication excludes warranty claims. Gasoline and oil
must be mixed in the ratio 40:1.
9 OPERATION
9.1
Unit operation
Attention! Do not use the unit without its protective cover. Always check the
unit's condition before you use it.
Before setting the unit into operation, check the unit's safety, especially for:
▪
On/Off stop control.
▪
Gas lever and its holder.
▪
Operation of protective devices.
▪
Firmness, damage, and worn-out cutting components.
▪
Grips/handles - must be clean and dry.
9.2
Use of the belt
▪
Equip the attached harness.
▪
Turn on the engine, return the throttle lever to the lowest speed position, and put the
harness hook to the hanging part of the machine.
▪
Adjust the length of the harness so that the blade may be parallel to the ground in the
working position. In order to prevent slack during operation, turn up to ensure the extra
length of the band and not loose.
9.3
Engine starting (cold engine)
Attention! Never start the engine near the refuelling site.
Important: Before starting the unit cut the cutting string to 13 cm in order to avoid an engine
overload during starting.
▪
Place the unit on a firm and flat surface. Make sure the cutting components do not touch
any items or the floor.
▪
Set the on/off stop control (7) to its "ON" position.
▪
Press primer bulb 3 to 5 times, until the air bubbles are out.
▪
Shift the choke lever (13) to its position marked "
▪
Pull the starter rope grip a few times in order to provide the engine with enough fuel/air
mixture. Pull until the engine starts.
▪
Move the choke lever (13) to its position marked "
verder en kan je van daar kopieëren)
▪
Keep running until the motor is warm enough.
Copyright © 2024 VARO
POWEG8013
".
". (dit zinnetje staat een paar regels
P a g e
| 7
EN
www.varo.com
Publicidad
