Covidien Kendall SCD 700 Serie Manual Del Usuario página 8

Section 2
Using the Kendall SCD™ 700 Series
9 Kendall SCD 700 Series
TM
Getting Started
Step 1. Set Up the Controller
Place the Controller near where you will be sitting or resting and within reach of an
AC power outlet. You can set the Controller on a bedside table or other flat surface, or
you can clip the Controller onto a foot board.
Placing on a Flat Surface
• Place the Controller on a flat, horizontal surface, such as a table, reasonably close to
where you will be sitting or resting.
• Make sure the Controller is not resting on any cords or tubing.
• Do not cover the Controller with blankets or other materials that may block the air
flow around the unit.
To Attach to a Foot Board
• To open the gap, using one or two hands, grasp and squeeze as shown in the picture.
• Lower the Controller onto the foot board so it straddles the foot board and release
the bed clamp.
• Make sure the Controller is firmly fastened.
NOTE
Save packaging materials for return of Controller and tubing after therapy.
Do not cover Controller with blankets or other materials that may block the air
flow around the unit.
WARNING
To avoid danger of suffocation, keep packaging material away from children.
Kendall SCD 700 Series
TM
Section 2 - Using the Kendall SCD™ 700 Series
10