Roborock S8 MaxV Ultra Manual Del Usuario página 14

Placing a malfunctioning robot on the dock manually
will end the current cleanup.
Resetting the System
If the robot does not respond when a button
is pressed or cannot be turned off, reset the
system by pressing the Reset button.
Note: After resetting the system, existing settings such
as scheduled cleaning and WiFi will be restored to
factory settings.
Restoring Factory Settings
If the robot does not function properly after
a system reset, switch it on. Press and hold
and at the same time, press the Reset
button until you hear the "Restoring
factory settings" voice message. The robot
will then be restored to factory settings.
Routine Maintenance
D
Note: The frequency of replacement may vary with the
actual situation. If abnormal wear occurs, replace the
parts immediately.
Main Brushes
* Clean every 2 weeks and replace every 6-12 months.
D1-1—Hair-Blocking Rings
D1-2—Main Brush Caps
D1-3—Main Brush Cover
D1-4—Latches
D1-5—Main Brushes
D1-6—Main Brush Bearing
D1-7— Turn over the robot and press the
two latches inwards to remove the
main brush cover.
D1-8— Pull out the main brushes and
remove the main brush bearings,
main brush caps, and hair-blocking
rings. Remove any entangled hair
or dirt at both ends of the main
brushes. Then, reinstall the hair-
blocking rings, main brush caps, and
then main brush bearings.
D1-9— Reinstall the main brushes. Firmly snap
the main brush bearings into place.
Only after the bearings are securely
installed, fit the main brush cover.
D1-10 Reinstall the main brush cover. Make
—
sure its four teeth are fully seated in
the slots, and press the main brush
cover until you hear it lock with a click.
Notes:
It is recommended to wipe the main brushes with a
wet cloth. If the main brushes are wet, air-dry them
away from direct sunlight.
Do not use corrosive cleaning fluid or disinfectant to
clean the main brushes.
To prevent injury caused by blades used to cut hair inside
the main brush cover, make sure to install two main
brushes in place before installing the main brush cover.
Flexible Side Brush
* Clean monthly and replace every 3-6 months.
Unscrew the side brush screw. Remove and
clean the side brush. Reinstall the brush
and tighten the screw.
14
Omnidirectional Wheel
* Clean as required.
D3-1— Use a tool, such as a small
screwdriver, to pry out the axle and
take out the wheel.
Note: The omnidirectional wheel bracket cannot be
removed.
D3-2— Rinse the wheel and the axle with
water to remove any hair and dirt.
Air-dry, reinstall, and press the wheel
and axle back in place.
Main Wheels
* Clean as required.
Clean the main wheels with a soft, dry cloth.
Dustbin
* Clean as required.
D5-1— Remove the magnetic top cover and
press the dustbin latch to take out
the dustbin.
D5-2— Remove the washable filter and
empty the dustbin.
D5-3— Fill the dustbin with clean water and
reinstall the washable filter. Gently
shake the dustbin, and then pour
out the dirty water.
Note: To prevent blockage, only use clean water without
any cleaning liquid.
D5-4— Leave the dustbin and the washable
filter to dry.