Descargar Imprimir esta página

Roborock S8 MaxV Ultra Manual Del Usuario página 18

Con sistema de relleno y drenaje
Ocultar thumbs Ver también para S8 MaxV Ultra:

Publicidad

Idiomas disponibles

Idiomas disponibles

Common Issues
Issue
Solution
The robot begins
The wall sensor, cliff sensors, or carpet sensor may be
to miss certain
dirty. Clean them with a soft, dry cloth.
spots
Poor cleaning
The dustbin is full and needs emptying.
performance
The filter is blocked and needs cleaning.
and/or dust
The main brushes are tangled up. Clean the main
leakage
brushes.
No or little water
Use the mobile app to increase the scrub intensity &
during mopping
water flow.
The dust container cover is not in place. Check and
install in place.
The status
Voltage error. Check that the local voltage meets the
indicator light is
requirements listed on the dock.
steady red
The refill and drainage pipes are not installed or not
properly installed.
Check that the water filter has been correctly installed.
Reduced
The main brushes or main brush cover is not properly
emptying
installed. Check and install in place.
performance or
The filter, suction inlet, air inlet, or dustbin is blocked.
unusual noise
Clean to remove blockage.
when emptying
Voice alert Error
42 occurs and
If the brush module stops at the left side, it may be
the maintenance
jammed. Remove any items jamming it.
brush module
If the brush module stops at the right side, the filter
stops at one side
may be blocked or is not installed in place. Clean and
of the cleaning
install in place.
tank
Issue
Solution
The mop cloths are not attached properly. Reinstall
Reduced
them.
mop washing
The floor is dirty. Change the mop washing mode to
performance
"Deep" in the app for better cleaning.
Auto-emptying is disabled. Check in-app settings.
Dock dust container cover is not installed. Check and
install.
Unable to
Auto-emptying will not be triggered if the robot
auto-empty
returns to the dock without cleaning.
The robot will not auto-empty after returning to the
dock in DND mode. Adjust cleaning or DND period, or
start emptying manually.
The mop cloths will not be washed if not used.
If the robot does not start from the dock or no dock
is found on the app map, it will not return to the dock
Unable to wash
for mop washing.
the mop cloths
The refill and drainage pipes are not installed or not
properly installed.
Check that the water filter has been correctly installed.
Auto-drying is disabled. Check in-app settings.
If you press a robot button or the robot departs the
Unable to start
dock during drying, the drying will end in advance.
auto-drying
In a humid environment, it is recommended to extend
the drying duration in the app to improve the drying
performance.
Unable to wash
Check that Mop Washing with Hot Water is enabled in
the mop cloths
the app.
with hot water
18

Publicidad

loading

Este manual también es adecuado para:

S82usv