Publicidad
ASSEMBLY
Batteries Recharging With On-Board Charger
Bring the machine on a level surface near to a single-phase socket (within 2m, 6.5
ft.) with an output of 120V, 60Hz, nominal current 10A.
Switch off the machine and proceed as follows.
1. Insert the plug into the mains socket.
2. Proceed to the charging keeping the tank lifted (see under paragraph
"BATTERY INSTALLATION AND SETTING OF THE BATTERY TYPE" in "BEFORE
USE"). 3. Keep the recharger connected until the indication of the end of
charge is visualized.
4. At the end of the charging, remove the plug from the mains socket.
Never leave the batteries completely discharged, even if the machine is not used. In
case of lead/acid batteries, please check the electrolyte level every 20 recharging
cycles and eventually top up with distilled water at the end of the recharge. Never
leave the batteries discharged for more than two weeks.
Danger of gas exhalations and emission of corrosive liquids.
Fire danger: do not approach with free flames.
12
Publicidad
