Publicidad
Starting Of The Machine
1. Turn the key (8) clockwise.
2. Check the battery type and the charge level on the display (1).
3. Press the base motor switch (5).
4. Press the suction motor switch (6).
5. Press the solenoid valve switch (4).
6. Pess down on the base lifting pedal (13) lower the base.
7. Adjust the solution valve lever (11) to open and adjust the solution detergent
flow.
The water starts to flow automatically when pushing the drive control levers
(9). On the instrument board the indicator of the solenoid valve switch (4) will
turn on. When the levers are released, the solution flow will stop.
8. Use the squeegee lifting lever (12) to lower the squeegee.
9. Pressing the drive control levers (9) cause the machine to start to move, the
base starts to vibrate and the squeegee starts to dry.
10. During the first stretches check that the squeegee adjustment guarantees
a perfect drying action and that the detergent solution flow is appropriate. It
has to be sufficient to wet the floor uniformly. Always consider that the correct
quantity of solution detergent depends on type of floor, dirtiness and machine
speed.
Forward Movement
The traction for the machine is given through an electronically controlled motor.
To move the machine, switch on the key and then rotate the drive control levers
placed on the handle bar, in forward you obtain the forward drive, in reverse the
backwards movement is obtained. The control acts in a progressive way, therefore
it is possible to vary the speed, depending on requirements, by rotating the lever as
it is necessary. During reverse motion the speed is reduced.
OPERATION
19
Publicidad
