Klarstein BALI BREEZE SMART Manual Del Usuario página 73

Drain pipe connection
1. Remove the fixed part to pull out
pipe of indoor machine from the
case. Screw the hexagon nut in the
left of the joint to the end with your
hand.
2. Connect the connecting pipe to the
indoor unit: Aim at the pipe center,
tighten the taper nut with fingers,
and then tighten the Taper nut with
a torque wrench, and the direction
is shown in diagram on the right.
The torque used is shown in the
following table.
Tightening torque table
The size of pipe (mm)
Ø 6/ Ø 6.35
Ø 9/ Ø 9.52
Ø 12/ Ø 12.7
Ø 15.88
Ø 19.05
Wrap the piping
1. Use the insulation sleeve to wrap the joint part the indoor unit and the
connection pipe, and then use insulating material to pack and seal insulation
pipe, to prevent generation of condensate water on the joint part.
2. Connect the water outlet with drain pipes, and make the connection pipe,
cables, and the drain hose straight.
3. Use plastic cable ties to wrap the connecting pipes, cables and drain hose. Run
the pipe sloping downward.
Taper nut
Indoor unit pipe
Spanner
Torque (Nm)
15–25
35–40
45–60
73–78
75–80
Connecting pipe,
drain hose
and cables
Plastic strap
Connecting pipe
Torque wrench
EN
71