Wheel Assembly - Kreg ACS Manual Del Propietário

Wheel Assembly

(1) Position the kickstand assembly relative
to the axle supports as shown.
(2) Slide the axle supports onto the axle with
the axle-support flanges facing each other.
(3) Slide the wheels onto the axles with the
offset wheel bearings toward the inside.
(4) Thread large flange lock nuts onto the
axles using the included wrenches,
or a ratchet wrench with a 15mm deep
socket and a 15mm combination wrench,
one on each end. Tighten the nuts to a
hard stop.
Set the wheel assembly aside.
Folding Base
(1) Thread foot levelers into leg assembly 1
(the one without folding handles).
(2) Place the Project Table-Top upside down
on a clean and sturdy work surface and
locate the end with two sets of four-holes
in the table top.
(3) Position leg assembly 1 flat on the table
top with the folding-brace anchor pates
engaging the four threaded studs
protruding from the table top.
ATTENTION:
The folding-brace anchor plates on the two leg
assemblies have different hole patterns and can only be installed in the
proper configuration.
(4) Fasten the upper bar of the leg assembly
to the table top with U-bolts, bar brackets,
and small flange lock nuts, using the
outer pairs of holes. Tighten the nuts
using the included wrenches or a 10mm
deep socket and ratchet wrench.
(5) Push down on the folded braces so they
contact the table top.
(6) Thread small flange lock nuts onto the
brace anchor-plate studs and tighten the
nuts using the included wrenches or a
10mm deep socket and ratchet wrench.
ASSEMBLY
1
3
2
1
1
3
2
4
6
5
4
1
4
4
2
4
6
5