Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Using the Miter Guide
(1) Install the Miter Guide in the table track
with the adjustable fence facing the infeed
end of the table. The width of the
workpiece determines which track to use.
Position the Miter Guide as close as
possible to the guide track.
(2) Position the workpiece under the guide
track and against the Miter Guide fence.
Apply moderate pressure to the center of
the Miter Guide to avoid deflecting the fence.
(3) Lower the guide track onto workpiece and
make the cut.
ATTENTION:
Always position the Miter Guide so cutting pressure
is toward, not away from, the guide.
ATTENTION:
For best results when making 90° and 45° cuts,
do not use the Miter Guide. Position the workpiece with Versa-Stops.
(See Versa-Stops.)
ACS Project Table Replacement Top
Replace a worn or damaged work surface with
a new precision-machined table top.
Contact ACS dealers, Kreg Customer Service,
or visit Kregtool.com
TELL US ABOUT YOUR EXPERIENCE. YOUR OPINION COUNTS.
We're always working to improve Kreg
project-building experiences. You can help by sharing your feedback at www.kregtool.com/feedback.
It only takes a couple of minutes, and will help us to create products and support that serve your needs better.
MITER GUIDE

REPLACEMENT PART

products and your satisfaction with them so that you have great
®
3
2
1

Publicidad

loading