Kreg ACS Manual Del Propietário página 26

REPETITIVE STOPS
Workpiece under guide track
3
3
(3) For cuts 1" to 8" wide, orient the stop with the knob at the rear and align the knob end with the desired
dimension on the secondary ruler. For cuts less than 7" wide, the ends of the stops extend under the guide track.
ATTENTION:
Regardless of the orientation of the Repetitive Stop,
always align the tab on the end of the stop indicated by the arrow with the
dimension on the primary or secondary ruler. The tab always indicates the
dimension on the correct ruler.
Arrow
Tab