Hach Polymetron 2582sc Manual Del Usuario página 12

3.7 Connect the sensor to the controller
Connect the bare wires of the sensor cable to the ultrapure amperometry module in the controller.
Refer to the illustrated steps that follow.
Notes:
• Make sure that the routing of the sensor cable prevents exposure to high electromagnetic fields
(e.g., transmitters, motors and switching equipment). Exposure to these fields can cause
inaccurate results.
• To keep the enclosure rating, make sure that all unused electrical access holes are sealed with an
access hole cover.
• To maintain the enclosure rating of the instrument, unused cable glands must be plugged.
• Make sure to connect all sensor ground/shield wires to the controller enclosure grounding screws.
Note: If the sensor cable is too short to connect to the controller, use a connecting cable and junction box to extend
the distance.
12 English