Hach Polymetron 2582sc Manual Del Usuario página 7

Figure 2 Product components
1 Sensor body
2 Flow chamber, stainless steel
3 Syringe for electrolyte, 5 mL
Section 3 Installation
Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the
document.
3.1 Installation guidelines
• Put the instrument in a location that has access for operation, service and calibration.
• Make sure that there is good view of the display and controls.
• Keep the instrument away from a heat source.
• Keep the instrument away from vibrations.
• Keep the sample tubing as short as possible to minimize the response time.
• Make sure that there is no air in the sample supply line.
4 Calibration cap
5 Membranes (4x)
6 Sensor cable, 10 m (33 ft)
C A U T I O N
7 Electrode
8 SC4500 Controller
9 Cable gland, M16
English 7