cecotec ENERGYSILENCE AERO 5290 WHITEWOOD Manual De Instrucciones página 47

2. Hanging ball holes
3. R clip
4. Adapter
5. Canopy
6. Decorative cover
7. Spring pin
8. Locking screw
- If you want the fan to hang lower, you must remove the hanging ball from the downrod
supplied for use with a longer rod (included). (If you wish to use the 6-inch downrod, follow
the steps below).
- To remove the hanging ball: Loosen the suspension ball fixing screw and remove the
pin and clip. Lower the hanging ball and remove the clevis pin. Slide the hanging ball off
the downrod, and slide it onto the longer rod (note that the top of the rod has a hole for
the fixing screw). Insert the stop pin into the top of the extended downrod and raise the
hanging ball. Make sure that the stop pin is aligned with the slots on the inside of the
hanging ball, tighten the fixing screw securely.
Tip: To prepare for passing the electrical wires through the rod, attach a small piece of electrical
tape to the ends of the electrical wires to hold them together when passing them through the
rod.
2. Loosen the main-body attachment fixing bolts and nut at the top of the motor housing.
Remove the pin and rod clip (if you have not already done so). Slide the rod down through
the canopy.
3. Pass the electrical wires through the rod and pull the wires protruding from the top of
the rod end.
Place the main-body attachment downrod into the main body anchorage of the motor
4.
housing and insert the pin and clip previously removed. Tighten the fixing bolts and the
main-body attachment nut securely. Lower the canopy onto the motor housing
Remote control connection. Fig. 8
Canopy assembly. Fig. 9
5. Lift the canopy up to the mounting bracket, aligning the loosened screws in the bracket
with the holes in the canopy. Turn the canopy to lock it. Re-insert the screws and secure
them all with a screwdriver.
6. Once you have secured the mounting bracket to the connection cover, you can hang the
fan. Hold the fan firmly with both hands. Slide the downrod through the opening in the
mounting bracket and allow the ball to rest on the bracket. Rotate the hole in the hanging
ball until it aligns with the tab on the mounting bracket.
Tip: Have someone else hold the ladder securely and bring the fan closer to you once it is on
the ladder.
ENERGYSILENCE AERO 5290 WHITEWOOD / BLACKWOOD
ENGLISH
47