cecotec ENERGYSILENCE AERO 5290 WHITEWOOD Manual De Instrucciones página 48

ENGLISH
Blade assembly. Fig. 10
7. Fix the iron part of the blade (A) with the screws. Do not fully tighten it until all 3 blades
are completely fixed. Fix the iron part (B) to the motor with screws. Do not tighten these
parts (B) completely until they are all in place.
Place the blades on the motor and proceed to the next step.
8.
LED-Lamp assembly. Fig. 11-12-13
Unscrew the screws. Attach the LED plate to the bottom of the fan by inserting the fixing
9.
screws into the holes. Then turn it until it is firmly in place. Then screw in the previous
fixing screw by aligning the hole in the screw and the hole in the bottom of the fan. Finally,
tighten the other two fixing screws to secure the LED plate. Fig. 11
NOTE: During the installation or when the LED lamp is removed, keep the insulation pads
intact. Over-tightening the screws may damage them.
10. Restore the cover and the lamp shade back to the LED panel, and secure them with
decorative clips and bolt nuts. Fig. 12
11. Position the panel as shown in figure 13.
4. OPERATION
Remote control. Fig. 14
1. Power button
2. Speed control
3. Winter function
4. Summer function
5. Natural Breeze
6. Natural Breeze shut-off
7. Timer controls
8. Light button
- Use the speed buttons to select the air power level.
- Press the power button to turn the appliance off.
- Use the timer buttons to select the fan operating time. The fan will turn off once the
selected time has elapsed.
- Press the light button to turn the fan's lamp on and off.
Winter Function
Press button 3 to activate the winter function. The fan will make air flow from the bottom
upwards, bringing cold air to the top of the room.
48
ENERGYSILENCE AERO 5290 WHITEWOOD / BLACKWOOD