Green Machine GM10514 Manual Del Operador página 35

CLEANING THE ENGINE
See Figures 65 - 68.
Clean the cylinder fins and flywheel fins with
compressed air or a brush periodically. Danger-
ous overheating of the engine may occur due to
impurities on the cylinder.
WARNING
Never run the saw without all the parts, includ-
ing the clutch cover and starter housing,
securely in place.
Because parts can fracture and pose a danger
of thrown objects, leave repairs of the flywheel
and clutch to factory trained authorized service
center personnel. Failure to follow these instruc-
tions could result in serious personal injury.
 Remove the screws and cylinder cover as
described previously.
 Clean the cylinder fins.
 Remove the screw from the front hand guard
post.
 Lift the front hand guard over the post.
 Lay the chain saw on its side with the bar and
chain on the ground.
 Remove the chain oil and fuel caps.
 Remove the three screws that hold the starter
housing in place.
 Lift off the starter cover and set aside.
 Replace chain oil and fuel caps to prevent con-
tamination during cleaning.
 Clean the flywheel fins.
 Remove the chain oil and fuel caps.
 Replace the starter housing. Reinstall screws
and secure.
 Replace the chain oil and fuel caps.
 Replace the cylinder cover. Reinstall screws and
secure.
NOTE: Check to ensure that the air filter is in the
proper position before reinstalling the cylinder
cover.
 Replace the front hand guard on the post.
 Reinstall screw into front hand guard post;
tighten securely.
MAINTENANCE
FRONT HAND
GUARD
Page 35
SCREW
CHAIN OIL
CAP
POST
STARTER
COVER
CLEAN CYLINDER
FINS
CLEAN FLYWHEEL
FUEL CAP
Fig. 66
Fig. 67
FINS
Fig. 68