Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Engine starts, runs,
and accelerates but
will not idle.
Chain turns at idle.
Bar and chain running
hot and smoking.
Engine starts and
runs, but chain is not
rotating.
TROUBLESHOOTING
Possible Cause
Carburetor requires
adjustment to idle speed.
Carburetor requires
adjustment to idle speed.
Air leak in the intake
system.
Chain oil tank empty.
Chain tension is too tight.
Oiler is not
functioning.
Chain brake is
engaged.
Chain tension is too tight.
Guide bar and
chain assembled incor-
rectly.
Guide bar and/or chain
are damaged.
Drive sprocket teeth
damaged
For any questions about operating or maintaining your product,
Your product has been fully tested prior to shipment to ensure
Turn idle speed screw "T" clockwise to increase idle speed.
Refer to Adjusting the Carburetor in the Maintenance section of
this manual.
Turn idle speed screw "T" counterclockwise to decrease speed.
Refer to Adjusting the Carburetor in the Maintenance section of
this manual.
Contact an authorized service center for a rebuild kit.
Oil tank should be filled every time fuel tank is filled.
Tension chain per instructions in Adjusting the Chain Tension in
the Maintenance section of this manual.
Run at half throttle 30 to 45 seconds. Stop saw and check for
lubricant dripping from SAFE-T-TIP
present, the chain may be dull or bar may be damaged. If no lubri-
cant is on the SAFE-T-TIP
Release chain brake. Refer to Operating the Chain Brake in the
Operation section of this manual.
Tension chain per instructions in Adjusting the Chain Tension in
the Maintenance section of this manual.
Refer to Replacing the Guide Bar and Chain in the Maintenance
section of this manual.
Inspect guide bar and chain for damage.
Contact an authorized service center for drive sprocket replace-
ment.
CALL US FIRST
call the GREEN MACHINE
your complete satisfaction.
Page 39
Solution
and guide bar. If lubricant is
®
, contact an authorized service center.
®
Help Line!
™
Publicidad
