Sony RM-V701 Manual De Instrucciones

SONY
Remote Commander
Operating Instructions
3-864-792-11(1)
RM-V701/V801
O 1998 by Sony Corporation Printed in Malaysia
[EE ÓQ*E. (A TET
About This Manual
The instructions in this manual are for RM-V701 and RM-V801.
Before you start reading, check your model number. RM-V701 is the
model used for illustration purposes. Any differences in operation
are clearly indicated in the text, for example, "RM-V701 only."
¡A a a A EE CN]
Setting Up the Remote Commander
Before you can start using the Commander, you must first set it up.
This manual describes everything you need to know to set up the
Commander, including:
* Preparing the batteries.
* Presetting the Commander with the codes for your TV, VCR, Cable
box, DBS tuner, and other audio components.
About Presetting the Commander
The Commander is preset at the factory to operate Sony brand
components.
If you're using the Commander with a Sony component, you won't
need to preset the Commander before you start using it.
To set up the Commander to use with other (non-Sony)
manufacturers' components, or to use with a component that is not
preset at the factory, you'll need to follow the instructions in this
manual to preset the Commander with the correct code number for
your components. (See the supplied "Component Code Numbers"
also.)
SP .. DEDO AA E:
Position Factory setting Component that can be preset
VISUAL
y
TV Sony TV TV
CABLE =
Cable box /DBS tuner /Receiver
(Amplifier) /CD player/Tape deck/ -
AV1/DBS Sony DBS tuner MD deck/DAT deck/TV/VCR
VCR Sony VHS VCR VCR
: (VTR3)
er
Position Factory setting Component that can be preset
AUDIO
AMP Sony receiver
TAPE Sony tape deck
Cable box /DBS tuner / Receiver
(Amplifier)/CD player /Tape deck/
* The Commander can be set up to operate only one component on
each position of the slide switch — unless their code numbers
happen to be the same. For example, you cannot set up the
Commander to operate a Sony TV and a Panasonic TV
simultaneously (because they use different code numbers).
* You may not be able to operate even a Sony brand component with
the factory presetting. In such a case, follow the procedure in
"Setting the Code."
installing the Batteries (RM-V701 only)
Slide open the battery compartment and insert two size AA (R6)
batteries (not supplied).
Be sure to line up the + and — on the batteries with the + and — on the
battery compartment.
When to replace the batteries
Under normal conditions, batteries will last up to six months. If the
Commander does not operate properly, the batteries might be worn
out. Replace the batteries with new ones.
Notes
* Replace both batteries with new ones.
* Do not take more than 20 minutes to replace the batteries;
otherwise, your setting of the code numbers will be erased.
Notes on Batteries
* Do not mix old batteries with new ones or mix different types of
batteries together.
* If the electrolyte inside the battery should leak, wipe the
contaminated area of the battery compartment with a cloth and
replace the old batteries with new ones. To prevent the electrolyte
from leaking, remove the batteries when you plan not to use the
Commander for a long period of time.
Charging the batteries (RM-V801 only)
Before operating the Commander
Be sure to set the start switch at the rear to ON using a ball-point pen
tip, etc.
Start switch