Publicidad
Idiomas disponibles
Idiomas disponibles
2. The position of the forward/reverse switch determines
the direction of the chuck rotation. Switch positions,
when tool is positioned as above, are:
— Forward (A above), the chuck rotates clockwise,
— Reverse
(B
counterclockwise.
3. The switch must be in either the forward or the reverse
position to operate. Center position locks the switch
off.
Forward/Reverse Switch (CTSS761)
The forward/reverse switch determines the rotating
direction of the quick disconnect, either clockwise or
counterclockwise.
A
B
Figure 4: Forward/Reverse Switch
A – Release switch for forward or
clockwise rotation.
B – Depress switch for reverse or
counterclockwise rotation..
To change the direction of the quick disconnect:
1. Be sure the screwdriver is stopped and not operating.
2. The position of the forward/reverse switch determines
the direction of the quick disconnect rotation. Switch
positions, when tool is positioned as above, are:
— Forward (A above), the quick disconnect rotates
clockwise,
— Reverse (B above), the quick disconnect rotates
counterclockwise.
3. The switch must be in either the forward or the reverse
position to operate. Center position locks the switch
off.
Trigger (CDRS761)
Depress the trigger to rotate the chuck. The lever must be
in a forward or reverse position to operate. The trigger
can be locked in the OFF position. Locking the trigger in
the OFF position helps to reduce the possibility of
accidental starting the drill when not in use. Place the
lever in the center position to lock the trigger. Lock the
trigger when not in use.
ZCDRS761CE Rev. B
above),
the
chuck
Trigger (CTSS761)
Depress the trigger to rotate the quick disconnect. The
lever must be in a forward or reverse position to operate.
The trigger can be locked in the OFF position. Locking the
rotates
trigger in the OFF position helps to reduce the possibility
of accidental starting the screwdriver when not in use.
Place the lever in the center position to lock the trigger.
Lock the trigger when not in use.
Torque Control
The tool has full torque when set in a drill position.
Overloading and stalling the tool while in the drill position
can cause motor burnout and can dramatically reduce
battery life.
Removing and Installing
Drill Bits (CDRS761)
This drill is fitted with a single sleeve keyless chuck for
one-handed operation of chuck. To insert a drill bit or
other accessory, follow the steps listed below:
1. Lock the trigger switch in OFF position.
2. Grasp the black sleeve of the chuck with one hand and
use the other hand to secure the tool. Rotate the sleeve
counterclockwise far enough so that chuck opens
sufficiently to accept the desired accessory.
3. Insert the accessory about 3/4" into the chuck and
tighten securely by rotating the chuck sleeve clockwise
with one hand while holding the tool with the other. To
remove the accessory, repeat step 2 listed above.
Do not attempt to tighten the drill bit (or other
accessory) by gripping the front part of the chuck
and turning the tool on. Personal injury may
result. Always lock trigger switch in OFF position
when changing accessories.
Removing and
Installing the Chuck
Removing the Chuck
Always remove the battery pack before replacing
the chuck.
1. Open the jaws of the chuck as wide as possible to gain
access to the chuck screw.
2. Using a T15 size Torx driver, remove the chuck screw
by turning it in the clockwise direction.
11
(04/19)
Publicidad
