Publicidad
Idiomas disponibles
Idiomas disponibles
3. Insert the short end of an Allen wrench (5/16" or
larger) into the chuck. Align the wrench flat with the
chuck and tighten the chuck securely.
Figure 5: Loosening the Chuck
4. While supporting the chuck on a solid surface, position
the drill so the Allen wrench is leaning to the left.
5. Strike the wrench with a hammer to loosen the chuck.
Turn the chuck counter clockwise to remove it.
6. Remove the chuck by turning it counter clockwise.
Assembly
Always remove the battery pack before replacing
the chuck.
1. Thread the chuck spindle into the drive shaft.
2. Insert the end of an Allen wrench (5/16" or larger) into
the chuck. Align the wrench flat with the chuck jaws
and hand-tighten.
3. While supporting the chuck on a solid surface, position
the tool so the Allen wrench is leaning to the right, and
strike the wrench with a hammer to tighten the chuck.
Figure 6: Tightening the Chuck
ZCDRS761CE Rev. B
4. Open the chuck jaws as widely as possible.
5. Using a T15 size Torx driver, insert the left-hand chuck
screw and tighten it in the counter clockwise direction
to 35±5 in. lb.
Inserting Bits/Shank
(CTSS761)
A
B
A – Tool Bit Quick Disconnect
B – Collar
1. The screwdriver bits supplied interlock by simply
pressing bit into tool holder of the screwdriver.
2. Make sure collar (B) has fully returned to initial
position.
3. Pull on bit to see if it is retained.
Locking the Screwdriver
The Cordless Screwdriver is fitted with an automatic
spindle locking system. When the screwdriver is locked,
it is possible to use it as a conventional, manual tool. This
is convenient when higher turning torque is needed. The
spindle locks automatically when the trigger switch is
released.
CAUTION:
When the screwdriver is locked, do not exceed
400 in. lbs. (45.2 N•m) turning torque. Safety
could be compromised or damage to tool could
result.
12
Figure 7:
(04/19)
Publicidad
