Metra 99-7620B Instrucciones De Instalación página 6

For models without factory navigation
7620-MAIN Harness
From the 20-pin harness to the aftermarket radio:
• Connect the Orange wire to the illumination wire.
(If the aftermarket radio has no illumination wire, tape off the Orange wire).
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the 12-volt battery wire.
• Connect the Red wire to the accessory wire.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
99-7620B
Connections to be made
If the vehicle has a factory installed BOSE sound system:
From the 12-pin harness to the aftermarket radio:
• Connect the Blue/White wire to the amp turn on wire (this wire must be
connected to hear sound from the factory amplifier).
• Connect the White, Grey, Green, and Purple RCAs to the audio outputs.
Note: If the vehicle has a factory installed BOSE sound system tape up
and disregard the following wires:
• White
• White/Black
• Gray
• Gray/Black
• Green
• Green/Black
• Purple
• Purple/Black
• White/Blue
6