Publicidad
Idiomas disponibles
Idiomas disponibles
From the 32-pin harness to the aftermarket radio:
• Connect the Blue/Pink wire to the speed sense wire (if applicable).
• If you wish to retain the factory AUX plug, connect the Red and White RCAs
with the "AUX INPUT" label to the AUX input (if applicable).
• If you wish to retain the factory installed DVD audio, connect the Red and
White RCAs with the "FROM DVD" label to an available source
(example: Video/Audio 1, AUX 1 or 2, etc.).
From the 16-pin harness to the aftermarket radio:
NOTE – This 16-pin plug must be connected for factory back-up camera to
function. There are two of this style plug available in the dash, use the factory
16-pin plug that is grouped with the factory radio plugs and went to the back
of the factory radio chassis.
• If you wish to show the factory installed DVD video on your aftermarket video
screen, plug the Yellow RCA into the "Video" input of aftermarket radio.
From the 22-pin harness to the aftermarket radio:
• If you wish to add an aftermarket backup camera or external video source,
plug the Yellow RCA into the desired source.
99-7620B
Connections to be made
Plug in:
Locate the factory wiring harness and antenna plug in the dash. All accessories,
switches, and especially air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition. Mount the new radio assembly
into the dash and reassemble dash in reverse order of disassembly.
• HVAC center panel to outboard harnesses. Left side controller plugs to left side
of main board and right side controller plugs to right side of main board.
• Vehicle to interface harness
NOTE – This 16-pin plug must be connected for factory back-up camera
to function. There are two of this style plug available in the dash, use the
factory 16-pin plug that is grouped with the factory radio plugs and went
to the back of the factory radio chassis.
• Aux in RCA to AUX input of aftermarket radio (if applicable)
• Rear DVD (if applicable)
• HVAC center panel to interface harness
ASWC-1
After the interface is initialized, plug the ASWC-1 into the 12-pin harness of
the 7620 harnesses and refer to the ASWC-1 instructions.
7
(if installing)
Publicidad
