Metra 99-7620B Instrucciones De Instalación página 8

For models with factory navigation
7620-NAV Harness
From the 20-pin harness to the aftermarket radio:
• Connect the Orange wire to the illumination wire.
(If the aftermarket radio has no illumination wire, tape off the Orange wire).
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the 12-volt battery wire.
• Connect the Red wire to the accessory wire.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
99-7620B
Connections to be made
From the 40-pin harness to the aftermarket radio:
• Connect the Blue/Pink wire to the speed sense wire (if applicable).
From the 32-pin harness to the aftermarket radio:
• If you wish to retain the factory AUX plug, connect the Red and White RCAs
with the "AUX INPUT" label to the AUX input (if applicable).
• If you wish to retain the factory installed DVD audio, connect the Red and
White RCAs with the "FROM DVD" label to an available source
(example: Video/Audio 1 or 2, AUX 1 or 2, etc.).
Note: In factory NAV vehicles – Factory back-up camera is retained
without use of the interface. AUX video-in is not available.
8