Descargar Imprimir esta página

AME AMESPHERE Manual De Uso E Instalación página 9

Publicidad

ISTRUZIONI DI SICUREZZA /SAFETY INSTRUCTIONS / SICHERHEITSHINWEISE / INSTRUCCIONES DE
SEGURIDAD/ INSTRUCTIONS DE SÉCURITÉ
6.2 ENGLISH
6.2.1 Disposal
Treatment of End-of-Life Electrical or Electronic Equipment (applicable in all European
Union countries and other European countries with separate waste collection systems)
This symbol indicates that the product must be handed over to an appropriate collection
point for the recycling of electrical and electronic equipment.
The AMESPHERE (cod. LPSUWB001, LPSUWB002, vt-7 PRO, TAGSAFETYUWB2,
TAGUWBCHARGER) is an assembly of electrical and electronic equipment.
By ensuring that this product is disposed of properly, you will help prevent potential
negative environmental and health consequences that could otherwise result from its
improper disposal. Recycling materials helps to conserve natural resources. For more
detailed information about recycling of this product, please contact your local city office,
your household waste disposal service. Penalties may be applicable for improper disposal
of electrical and/or electronic equipment, in accordance with local regulations.
6.2.2 DESTINATION AND LIMITATIONS OF USE
The AMESPHERE (cod. LPSUWB001, LPSUWB002, vt-7 PRO, TAGSAFETYUWB2, TAGUWBCHARGER)
(hereinafter also referred to as 'System' or 'Product') is intended for installation on industrial trucks. The
Product is an assistance system for human-vehicle and vehicle-vehicle proximity detection. It does not
constitute a personal safety system and is not a safety device. It is not covered by Annex IV of Directive
2006/42/EC and as such cannot be used for residual risk reduction. Unless otherwise expressly stated in
writing by A.M.E. on a case-by-case basis, the System is not intended for use in special environments such as
flammable gas atmospheres, explosive atmospheres, or corrosive atmospheres. The purpose of the System is
to provide an additional aid to the driving of industrial trucks. While driving, however, the driver's full attention is
required at all times and the driver must be ready to intervene and operate the controls to avoid possible
collisions or other hazardous situations, regardless of and apart from the System.
The System is not a substitute for the driver's attention and judgment and in no way obviates the need for the
driver to slow down or brake in a hazardous situation, nor does it relieve the Buyer and the operator of the need
to adopt normal safety procedures as required or appropriate.
The control of the vehicle remains in any case in the total responsibility and availability of the driver, who must
always evaluate the conditions in which the vehicle moves, paying attention to the presence of operators, other
vehicles, obstacles, and dangers in general.
6.2.3 PRODUCT INSTALLATION AND DRIVER INSTRUCTIONS
When installing the Product, it is necessary to comply with the instructions and indications provided by the
vehicle manufacturer in the relative user manual (electrical and mechanical connections, etc.). The installation
must be carried out by personnel suitably trained for this purpose and must not make or involve changes to
the vehicle that affect the characteristics and/or requirements relevant to the declaration of conformity of the
vehicle itself.
The System shall be installed in such a way that, under any circumstances, the driver of the vehicle is not
prevented from bringing the vehicle to a safe state. The installation shall also not compromise the ergonomics
and visibility of the driving position. The operator must be warned against developing dependence on
assistance systems.
Under no circumstances should the driver abandon normal cautionary behaviours.
The operator must be properly instructed that even in the event of a sudden failure of the system, all safety
procedures at the operating site, such as maximum speed in each area, must still be observed and caution
Advanced Microwave Engineering S.r.l.
Head Office: Via Lucca 50-54, 50142 Florence, Italy - C.F/P.IVA/n. iscr. Reg. Impr. di Firenze 05016620485
-
Capitale sociale: € 99.000 i.v.
T. +39 055 73921 - M. info@ameol.it - www.ameol.it
AME_Man_AMESPHERE_KEY_MultiLanguage_V01 Pag. | 9

Publicidad

loading

Este manual también es adecuado para:

Lpsuwb001Lpsuwb002Vt-7 proTagsafetyuwb2Taguwbcharger