Descargar Imprimir esta página

Parkside PDNB 6.3 C3 Traducción De Las Instrucciones Originales página 6

Punzonadora neumática para chapa

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 91
1. Introduction
Congratulations on the purchase of your new ap-
pliance. You have chosen a high-quality product.
The operating instructions are an integral part of this
product. It contains important instructions for safety,
use and disposal. Familiarise yourself with all oper-
ating and safety instructions before using the prod-
uct. Only use the product as described and for the
specified areas of application. Hand over all docu-
ments when passing the product on to third parties.
1.1 Intended Use
This appliance is intended for cutting sheet metal,
aluminium and similar materials in the thickness
specified. This appliance may only be powered with
a compressed air supply. The maximum permissible
working pressure must not be exceeded. This unit
must not be operated with explosive or flammable
gases! Any other use or modification of the unit is
considered improper, involves considerable risk of
accidents and is also not permitted. We accept no
liability for damage resulting from improper use. The
appliance is intended for private use only and may
not be used for commercial or industrial purposes.
1.2 Scope of Delivery
1 Air Nibbler
1 Plug nipple (pre-assembled)
1 Instruction manual
6
GB/IE/NI/CY/MT
AIR NIBBLER PDNB 6.3 C3
1.3 Equipment
1 Plug nipple (pre-assembled)
2 Switch-on lock
3 Trigger
4 Stamp
5 Matrices
1.4 Technical Data
Rated air pressure:
Rated speed:
Compressed air
connection:
Cutting capacity/
Material thickness max.: Sheet metal 1,2 mm
Cutting width:
Dimensions:
Mass
(without accessories):
Noise emission values
Measured value for noise determined according to
ISO 15744:
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
WARNING!
The noise emission values given in these instruc-
tions have been measured according to a meas-
urement method standardised in ISO 15744 and
can be used for tool comparison. The noise emis-
sion values will vary according to the use of the
air tool and may in some cases be higher than
the values given in these instructions. Noise emis-
sion levels may be underestimated if the air tool
is used regularly in such a manner.
max. 6,3 bar
3600 min
-1
1/4"
Aluminium 1,6 mm
5,5 mm
229,5 x 105,8 x 42,6 mm
ca. 0,91 kg
= 89,1 dB (A)
= 3 dB
= 103,1 dB (A)
= 3 dB

Publicidad

loading

Este manual también es adecuado para:

435173 2304