cecotec EnergySilence Aero 5200 Black Manual De Instrucciones página 50

ENGLISH
7. Align the holes in the blades with the screw holes in the motor. Once all blades are
attached, tighten all the screws. Before securing screws permanently, repeat this step
with the remaining blades.
Note: tighten the blade screws a second time.
LED-Lamp assembly. Fig. 11-12-13
8. Unscrew the screws. Attach the lamp panel to the bottom of the fan by inserting the
other two locking screws heads into the slots. Twist the panel into place. Then, secure
the previous locking screw by aligning the screw hole and the hole at the bottom of the
fan. Tighten the other two locking screws to secure the lamp panel. Fig. 11
NOTE: during the installation or when the LED lamp is removed, keep the insulation pads intact.
Over-tightening the screws may damage them.
9. Connect the LED light to the fan as shown in figure 12.
Align the decorative cover with the engine tread and tighten it clockwise, as shown in
10.
Fig.13.
4. OPERATION
This fan can be operated with the remote control.
Fig. 14
1. Power indicator light
2. Speed buttons
3. Off button
4. Timer buttons
5. Light button
6. Battery compartment
- The indicator will light up while the appliance is in operation.
- Use the speed buttons to select the power level. 3 speeds available:
- I
- II
- III
- Press the off button to switch the appliance off.
- Use the timer buttons to select the operation time of the appliance. Select up to 8 hours
of operation.
NOTE: once the selected time has elapsed, the fan will switch off automatically.
- Press the light button to turn the fan's lamp on and off. There are 3 shades available to
achieve the perfect atmosphere in an effective and affordable way.
50
ENERGYSILENCE AERO 5200 BLACK | WHITE