Tabla de contenido
Publicidad
Bobbin Winding
@ For horizontal spool pin
_B) For additional spool pin
_,
Pull the handwheel
out to the right.
Draw thread from the spool.
(_3) Guide the thread around
the thread
guide.
(4) Thread through
the hole in the bobbin
from the
inside to the outside.
_5) Put the bobbin
on the bobbin
winder
spindle.
_6_ Push the bobbin
to the right.
_') With free end of the thread
held in your hand,
depress
the foot control.
Stop the machine
when it has made a few turns and cut the thread
close to the hole in the bobbin.
Depress
the foot control
again.
When the bobbin
is fully wound,
it stops automatically.
Return the
bobbin
winder
to its original
position
by moving
the spindle
to the left and cut the thread
as
shown.
_9) Push the handwheel
in. The machine
wilt not
function
until the clutch
is engaged.
NOTE:
Position
of the bobbin winder
stopper
is
adjustable
for the required
amount
of
thread
on the bobbin
(example
1/2 full or
full etc.).
Use a screwdriver
and loosen
the screw
one turn or less so that you can adjust the
position
of the bobbin
winder
stopper.
Do not take out the screw all the way.
f
S
i
®
®
f
®
t
jl=_
®
22
Publicidad
Tabla de contenido
