Threading The Machine - Sears Kenmore 385.17626 Manual De Instrucciones

Threading the Machine
• Threading the Machine
• Raise the thread take-up lever to its highest
position by.turning the handwheel
counterclockwise.
• Raise the presser foot lifter.
Place a spool on the spool pin, with thread coming
off as shown.
_ Draw the end of thread around the upper thread
guide.
_ While holding the thread near the spool, draw the
end of the thread down around the check spring
holder.
,_3_) F irmly draw the thread up from right to left over
the take-up lever and down into the take-up lever
eye.
_) Slide the thread behind the needle bar thread
guide on the left.
6) Thread the needle from front to back or use a
needle threader.
We recommend using the convenient needle
threader(#200262101), included with your
machine.
• Drawing up Bobbin Thread
_1_.Raise the presser foot. Hold the needle thread
lightly with your left hand and rotate handwheel
counterclockwise for one complete turn.
@_ Bring the bobbin thread up by pulling the needle
thread up.
_ Pull both threads under and to the back of the
presser foot, leaving 4 to 6" (10 to 15cm)
of thread clear.
S
S
J
26