Standards Compliance
Model No.
Single leg
VIKCC-L
The EU Declaration of Conformity can be found at www.vito-tools.com.
WARNING
Manufacturer must provide this instruction to users, then read and understand it carefully before using this equipment.
This instruction supplied by the manufacturer shall be provided in the languages of the country of destination.
Failure to follow as below warnings on the use of this equipment may result in serious injury or death:
1.
The persons who are suffering from high blood pressure, heart disease, severe anemia, acuity, etc. are forbidden doing
aloft work. The people who is tired, poor eyesight and drunk is not allowed doing aloft work too. People who are in a
state of mental agitation, panic and anxiety are not allowed to work at high altitude for the time being.
2.
The equipment shall only be used by a person trained and competent in its safe use.
3.
A rescue plan shall be in place to deal with any emergencies that could arise during the work.
4.
Against to make any alterations or additions to the equipment without the manufacturer's prior written consent, and
that any repair shall only be carried out in accordance with manufacturer's procedures.
5.
The equipment shall not be used outside its limitations, or for any purpose other than that for which it is intended.
6.
Before use ensure about the compatibility of items of equipment when assembled into a system. Ensure that all
items are compatible and appropriate for
items of equipment in which the safe function of any one item is affected by or interferes with the safe function of
another. Periodically check the connection and adjustment of the components to avoid accidental disconnection and
loosening.
7.
Personal protective equipment must be withdrawn from use immediately when any doubt arise about its condition for
safe use and not used again until confirmed in writing by a competent person that it is acceptable to do so.
8.
Personal protective equipment must be withdrawn from use immediately when it has been used to arrest a fall.
9.
It is essential for safety that the anchor device or anchor point should always be positioned, and the work
carried out in such a way, as to minimize both the potential for falls and potential fall distance. Where it is essential
that the anchor device/point is placed above the position of the user, the manufacturer shall make a statement to that
effect.
10. It is essential for safety to verify the free space required beneath the user at the workplace before each occasion of use,
so that, in the case of a fall, there will be no collision with the ground or other obstacle in the fall path.
11. There are many hazards that may affect the performance of the equipment and corresponding safety precautions that
have to be observed e.g. : extremes of temperature, trailing or looping of lanyards or lifelines over sharp edges,
chemical reagents, electrical conductivity, cutting, abrasion, climatic exposure, pendulum falls.
12. It is essential for the safety of the user that if the product is re-sold outside the original country of destination the reseller
shall provide instructions for use, for maintenance, for periodic examination and for repair in the language of the country
in which the product is to be used.
13. A suitable precaution should be taken that loading in the case of user over an edge, such as add a wear-resistant
protective cover on the outside of the lanyard.
14. Before use for the first time, the user should carry out a comfort and adjustability test in a safe place, has sufficient
adjustment and is of an acceptable comfort level for the intended use.
15. The safety lanyard shall be a personal issue item.
16. Do not expose the equipment to any hazard which it is not designed to withstand. Consult VITO in cases of doubt.
17. Do not use this equipment around moving machinery, electrical hazards, sharp edges and abrasive surfaces.
18. Do not make the lanyard used choke hitch, this will affect the performance of the lanyard.
19. Do not use an anchorage point that will not take a shock load of min 12 kN.
20. Do not anchor with attachment point to a structure that can fall itself. For instance: window cleaner's cradle free standing
ladder or other loose structures.
21. Do not wrap this lanyard around any structure and connect the lanyard back onto itself, unless the lanyard has been
specifically designed to do so.
Type
Twin legs
√
Standard Ref.
EN 354:2010
EN 358:2018
√
√
the
proposed application. It is forbidden
to
use combinations of