Skoda FAA 710 002 Instrucciones De Montaje página 10

- 5 -
- Cut off the nozzle of the tube with gluing cement (C) according to the picture so that the
bore diameter of the nozzle is about 6 mm.
- Apply the gluing cement in the shape of a "caterpillar" on the prepared spoiler surfaces. The
approximate size of the "caterpillar" is 6 mm.
GB
- 6 -
- Tear off the covering strips of the glued bands in a distance of about 20 mm. Bend their
extremes over the spoiler edge and fix with suitable adhesive tape.
- 7, 8 -
- Apply the prepared spoiler on the cleaned surface of the 5
rect alignment (the spoiler edge must copy the edge of the 5
- Tear off all the covering strips and press the spoiler down.
- Fix the glued spoiler with car adhesive tape (it is not included in the set).
- This operation must be carried out by two workers.
With the spoiler glued in this way, the vehicle must be left at rest for 48 hours in a pro-
tected room (temperature 15-30°C).
The gluing cement must get properly dry. Remove the adhesive tapes after 48 hours. If
parts of glue are pressed out around the glued part, remove them with a plastic filler
knife and clean them with the HHA 381 011 de-greaser.
th
door, pay attention to its cor-
th
door).