Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the
flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and
Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.
LIGHTING THE MAIN BURNERS:
1. Open lid before lighting burner.
2. Make sure all control knobs are in the "OFF" position.
3. Select the burner to be lit. Push and hold down the control knob and turn
to "HIGH". You should hear the igniter click.
4. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait
5 minutes to allow gas to dissipate and repeat lighting procedure.
5. Repeat steps 3 – 4 for lighting each burner. If burner does not ignite, wait
5 minutes, see "Match Lighting the Main Burners" section.
6. To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off the gas flow
from the cylinder.
MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting.
2. Turn the burner control knobs to "OFF".
3. Place paper match in the end of the matchlighter. Strike the match and place
through cooking grill and under heat tent approximately 1/2" (1 to 2 cm) right
above the burner.
4. Turn burner control knob of that burner to the "HIGH" position. The burner should
light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for
gas to dissipate and repeat lighting procedure.
6. Once lit, to light other burners, repeat Steps 2 - 5.
7. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply.
Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and
corrected. See "Trouble Shooting" section of this manual.
Note:
If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the
flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and
Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.
LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is in the "OFF" position.
3. Push and hold down side burner control knob and turn to the "HIGH" position.
You should hear the igniter click.
4. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5
minutes to allow gas to dissipate and repeat lighting procedure.
5. To turn off, turn control knob clockwise until it locks in the "OFF" position.
ROTISSERIE
Matchlighter
10
Publicidad
