Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
Step 10. Plug in and place
WARNING
•
BEFORE OPERATING OR TESTING, follow the grounding requirements on pages
16–17 in this manual. Improper connection of the grounding plug can result in
a risk of electric shock.
Please review "Electrical requirements" on pages 16–17.
•
Altering any part of this system may result in a short or overload.
Plug in the power cord. Make sure the outlet meets local or national electrical
1.
codes as referenced on pages 16–17.
2.
Slide the range into place.
3.
Check the gas supply line to make sure it did not get damaged and it stayed
connected during positioning.
4.
Check to make sure the back leg of the range has slid into the anti-tip bracket.
Carefully tip the range forward to ensure that the anti-tip bracket engages the
back brace and prevents tip-over.
NOTE
If the power cord is plugged in improperly, the following message appears on the
display.
•
LCD, PMOLED : Wire installation fail
•
LED : bAd LinE
Reconnect the power cord properly, and the message disappears.Step 11. Moving
and placing the range
28 English
DG68-01554A-00_IM_DOP48T960DS, DOP48T963DS_DA_EN+MES+CFR.indb 28
DG68-01554A-00_IM_DOP48T960DS, DOP48T963DS_DA_EN+MES+CFR.indb 28
Step 11. Moving and placing the range
1.
2.
Air Sled Insert
NOTE
Adjust the leveling legs only as far as necessary to level the range. Extending the
leveling legs more than necessary or removing legs can cause the range to be unstable.
3.
4.
5.
6.
7.
Due to the weight, heavy equipment movers
such as Air Sled should be used to move
this unit. The weight must be supported
uniformly across the bottom.
After transporting the range by Air Sled
where you want, the range can be leveled
by adjusting the legs with a wrench while
Air Sled is supported. Using a wrench, level
the range by turning the front leveling legs
in or out as necessary. Counterclockwise
shortens the leg and lowers the range.
Clockwise lengthens the leg and raises the
range.
If range is next to or between cabinets,
make sure the cooktop (without the
surface burner grates) is level with the
countertops.
Position an oven rack in the center rack
position.
Check the level of the range with a
carpenter level using the two positions
shown on the left.
After the range becomes level, Use Air
Sled to move the range away from the
wall so that the anti-tip bracket can be
installed.
After installing and leveling the range,
carefully remove Air Sled and install
front leg covers (right, center and left).
2023-07-05 오후 2:19:27
2023-07-05 오후 2:19:27
Publicidad
