Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Orient each main brush so that the shapes of the
ends match the mounting areas of the appliance, as
shown in the figure.
If the shapes of the ends do not match, reverse the left-
right orientation of the main brush so they match.
2
3
Fig.56
► 1 . Main brush 2. Minus shape 3. Plus shape
8.
Fit a main brush onto the brush shaft of the appli-
ance in the direction indicated by the arrow in the figure.
Fig.57
► 1 . Brush shaft
2
3
1
1
9.
Fit a main brush into mounting area of the appliance, in the
direction indicated by the arrow in the figure, and secure it in place.
Fig.58
NOTE: If the shapes of the ends do not match, you
will not be able to mount the main brush. In this case,
go back to step 7 and redo the process.
10. In like manner, mount the other main brush.
Fig.59
CAUTION:
After mounting the main brushes,
check that the shapes are correctly engaged.
NOTE: If the main brushes are worn down to a
shorter length, replace them.
Cleaning the side brush
For the procedure for mounting and removing the side
brush, refer to "Attaching and removing the side brush."
1.
Remove the side brush.
2.
Shake off dust, and wash the brush with water if it
is very dirty. After washing, leave the brush to dry in the
shade; do not use it until it is completely dry.
Fig.60
21 ENGLISH
Publicidad
