Descargar Imprimir esta página

Makita VS001G Manual De Instrucciones página 23

Barredora aspiradora inalámbrica
Ocultar thumbs Ver también para VS001G:

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning the sponge filter
CAUTION:
After cleaning the sponge filter, be
sure to install it on the waste container. If washed
in water, dry it up before installing.
When the sponge filter is clogged with dust, remove it
from the waste container and then wipe it off or wash
in water.
1.
Remove the sponge case from the waste
container.
2.
Open the sponge case to remove the sponge filter.
2
1
Fig.66
► 1 . Waste container 2. Sponge case 3. Sponge filter
3.
Wipe off the sponge filter or wash in water.
4.
Install the sponge filter in its original position.
Cleaning the tube
When using the dust bag (optional accessory), the tube
may become clogged with fine refuse such as sand,
pebbles, and small fallen leaves.
1.
Pull the tube from the dust bag frame.
2.
Remove the refuse from the tube.
1
Fig.67
► 1 . Dust bag frame 2. Tube
3.
Install the tube in its original position.
3
2
23 ENGLISH
Periodic inspections
To ensure a long service life for the appliance and
safety usage, perform the inspections listed below
periodically.
Daily inspections
Waste container: empty the container.
Filters: if they are dirty, cleaning them.
Brushes: if string-like refuse get entangled,
remove it.
Control and movable parts: check that they move
smoothly.
Weekly inspections
Main brush height: if the height is inappropriate,
readjust it.
Screws (when using multifunction adapter): if they
are loose, tighten them.
Replacement/replenishment of
consumable items
Brush replacement
If the main brushes and side brush become worn out,
ask your local Makita service center for replacement.
Replacing the main brushes
Replace the main brushes if they cannot be adjusted
appropriately. Refer to "Main brush height adjustment."
For removing and mounting the main brushes, refer to
"Cleaning the main brushes."
Replacing the side brush
Replace the side brush if it does not contact the floor
when the side brush height adjusting knob is turned to
the lowest position. Refer to "Side brush height adjust-
ment."
For removing and mounting the side brush, refer to
"Attaching and removing the side brush."
MAKITA LIMITED
WARRANTY
Please refer to the annexed warranty sheet for the
most current warranty terms applicable to this product.
If annexed warranty sheet is not available, refer to the
warranty details set forth at below website for your
respective country.
United States of America: www.makitatools.com
Canada: www.makita.ca
Other countries: www.makita.com

Publicidad

loading