Quick-Programming - SEVERIN MW 7848 Instrucciones De Uso

Ocultar thumbs Ver también para MW 7848:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 53
Note:
1.
The cooking time cannot be set while pre-heating is in progress.
2.
If the cooking time is not set within 5 minutes after pre-heating is complete, 5 beep signals are heard and the unit will
automatically go back to Stand-by mode.
Note: Steps 3-7 can be omitted, if pre-heating is not required.
Defrost programme according to time or weight (
This defrosting programme is useful for defrosting food by either setting the weight of the food to be defrosted, or by directly
setting the defrosting time. For delicate food we recommend defrosting on the level 'Low' (see table Power setting), to ensure
that the food is defrosted with an even, low temperature setting.
The indicator 'dEF1' represents weight-based defrosting; 'dEF2' represents time-based defrosting.
Helpful notes:
∙ The defrosting proces s should be interrupted at regular intervals and those food portions already defrosted should be
taken out; this is to ensure that food already defrosted will not take away heat from food that still requires defrosting.
∙ Should the food not be completely defrosted after the pre-set defrosting time has elapsed, it is advisable to limit any
further defrosting times to 1-minute periods until the food is fully defrosted.
∙ Food stored in plastic containers or wrapped in plastic should be left standing for a while after it has been taken from the
freezer. Wait until the food can be easily detached from the plastic, before it is put into the oven inside a container suitable
for use with microwave ovens.
1.
Press
once or twice. The display shows 'dEF1' or 'dEF2' and, in addition, the symbols
2.
Use the rotary control to set the weight of the food to be defrosted (between 100g and 2000g) or the desired defrosting
time (between 00:05 and 95:00).
3.
Press
to start the defrosting process. An acoustic signal is heard, and the symbols

Quick-programming

The most commonly used microwave time-settings can be called up simply by pressing
power setting is always 100 %. Each press on the key adds 30 seconds to the cooking time.
Note: the cooking process starts as soon as the key is pressed for the fi rst time.
Example: to programme the microwave function for a cooking time of 2 minutes at 100 % power.
1.
Press
4 times. The display shows 2:00, and the symbol
Automatic cooking programmes
These automatic cooking programmes are helpful when cooking food without having to select any particular settings, e.g.
for power or cooking time. Once a programme has started, the currently selected function is indicated by the appropriate
symbols on the display (e.g.
1.
Use the rotary control to selec t the desired programme. The display shows the corresponding programme symbol and
'Auto', and the programme indicator 'A-1'starts fl ashing.
2.
Press
to confi rm the programme.
3.
Use the rotary control to set the desired weight.
4.
Press
to start the programme.
Note: The menu 'A-8' (Cakes) uses the hot-air function. It fi rst pre-heats to 160 degrees and then starts with the automatic
cooking programme. Once pre-heating is complete, 2 beep signals are heard and the temperature display starts fl ashing.
Place the cake into the microwave and press
24
)
for microwave).
to start the programme.
. With this function, the microwave
starts fl ashing.
and
.
and
start fl ashing.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mw 7868

Tabla de contenido