InSTaLLaTIOn PROCEduRE
5. drain Installation
A pply pipe tape to the flange
threads
I nsert flange into the drain hole
A ssemble the gasket, flange
nut, and lock nut
i nstall the drain body onto the
flange
s ecure the drain assembly by
tightening the flange nut and
locknut
a pply pipe tape to the threads
of the tail piece and install the
tail piece to the drain body
i nsert the drain stopper into the
flange
a ssemble the pivot rod as shown in the diagram
i nsert the pivot rod into the drain stopper hole� Tighten the lock
nut
i nsert the lift rod and pivot rod into the connecting block� Tighten
both rods with screwdriver
6. Supply Connections
C onnect water supply tube to
the valve body
T ighten connections with
adjustable wrench
C heck all connections to make
sure there are no leaks
drain stopper
pipe Tape
Flange nut
locknut
drain Body
Tail piece
lift rod
Flange
gasket
pivot rod
gasket
spring
Connecting
seal
Block