Installation Procedure; Spout Installation - Toto SOIRÉE TL960dDLQ Manual De Instrucciones Y Del Propietario

InSTaLLaTIOn PROCEduRE

1. Spout Installation

 i nsert spout through the center
hole
 i nsert the lift rod from
underside of the faucet and
thread it into the lift knob
 s lide the bracket into place
and secure the spout with nuts
 a djust the spout to face
forward� hold the spout in
place� Tighten nuts
 i nstall the T-Connector onto
the spout shank� do not over
tighten
2. Valve body Installation
 i nsert the valve body from
underside of the sink� make sure
the Cold side is on the right
and hoT side is on the left
 p lace the rubber gasket
underneath the deck adapter and
screw the deck adapter onto the
valve body until it bottoms out�
make sure the rubber washer
lays flat in the groove of the
deck adapter
 s crew the decorative cap onto
the deck adapter� Take care not
to cross thread
 p osition the valve body as
shown below then tighten the
locknut
 r epeat procedure for the other
valve
spout
T-Connector
rubber
gasket
Bottom View
4
lift knob
Bracket
nut
lift rod
handle adapter
decorative Cap
deck adapter
rubber washer
Valve Body
lock nut