SEVERIN MW 7817 Instrucciones De Uso página 20

General operating sequence
- Place the food to be heated in a suitable container. Place the container onto the turntable
in the oven.
- When food is placed in the microwave, it should be covered to prevent it from drying
out. Glass or plastic covers especially designed for use with microwave appliances are
available at most kitchenware dealers.
- When using the grill, hot-air or any of the combination functions, do not cover the
food to be cooked. The grill rack may be put directly on the glass turntable with the
food itself on the grill rack.
- Close the door and set the desired programme.
- As the programme is started, the turntable starts to rotate. During operation, the interior
light remains on.
- If, during operation, the door is opened or the
the food in order to ensure that the temperature is evenly distributed), the timer and
programme functions are automatically suspended. The programme will automatically
resume only after the door is closed again and the
- Press twice to interrupt the programme.
- Beep signals indicate that the pre-programmed period has elapsed; at the same time, the
interior lighting switches off.
- Open the door and remove the container with the food.
- In order to achieve an even heat distribution through the food, the container should be
set aside for several minutes.
- The cooking times generally depend on several factors.
- The microwaves penetrate the surface of the food. For larger pieces of food, a longer
cooking time is therefore needed than for the same amount of food if cut into pieces.
The food should also be evenly distributed on the plate.
- To ensure that any germs in the food are safely destroyed, the food needs to be
exposed to high temperatures for a sufficiently long period.
- As a basic rule:
half the amount
double the amount - almost double the time recommended.
Setting the clock:
Once the unit has been connected to the power supply, the display shows '0:00' and an
acoustic signal is heard.
Note: The time display does not start counting, unless the clock has been set. The time
setting process can be cancelled by pressing the
The clock must be set when the appliance is connected for the first time, and also if a power
failure has reset the clock.
1. Press once. The hour digits start flashing in the display.
2. Turn the rotary control to set the correct hour. The hour must be in the range 0-23.
3. Press . The minute digits start flashing.
4. Turn the rotary control to set the correct minutes. The range must be 0-59.
5. Press to finish setting the time. The symbol ' : ' flashes and the correct time is
shown.
The microwave function
To programme the unit for cooking, the correct mode (microwave), the required power
setting and the cooking time must be selected, before the programme sequence can be
- half the time recommended (for the full amount).
key is pressed (e.g. to stir or to turn
key is pressed.
key.
20