Inputs Ext. Lösch. And Stopp; Terminal Block; Fuses; Connecting The Mains Voltage - Heyl Testomat 808 Manual De Instrucciones

!
DANGER
Inputs EXT. LÖSCH. and STOPP
Please refer to the section entitled
on page 25 for a description of the inputs "EXT. LÖSCH. (Delete
externally)" and "STOPP"

Terminal block

Please refer to the sections entitled
"Connecting the inputs and
on page 21 and
description of the terminal block

Fuses

The following fuses can be found on the base circuit board.
No.
Designation
F1

F2
F3


F4

F5
Please refer to the section entitled
accessories" on page 44 for the article numbers when reordering
and
fuses.

Connecting the mains voltage

Installation of the terminal compartment cover
For safety reasons, it is imperative to reinsert the terminal
compartment cover after connecting the mains voltage and the
system components, as the terminal compartment contains cables
that are connected to hazardous voltages. In doing so, you eliminate
unintended contact with the terminals and contact of two lines of
different voltages and prevent a fatal electric shock.
Please also ensure that the cables are not pinched when in-
stalling the terminal compartment cover!
Only connect the instrument to the specified mains voltage. Refer to
the rating plate for the appropriate mains voltage. Connect the cables
as follows:

Open the housing cover and subsequently loosen the two fas-
tening screws at the top and bottom of the door to the interior of
®
Testomat 808. The door can now be opened and the terminal box
accessed.
"Description of the signal

.
"Connecting the mains
outputs" on page 23 for a

.
Function
Relay protection fuse
Primary fuse
Secondary fuse
Pump motor fuse
"Testomat
®
Installation
inputs"
voltage"
Comment
4 A
230 V / 0.1 A
115 V / 0.2 A
24 V / 1 A
1 A
0,315 A
808 2019 spare parts
21