Tabla de contenido
Publicidad
Recording from other devices
8
Press and hold [REC *]
for 1 second or more.
The unit enters the recording
standby.
9
Play back the external device and adjust the
input/output level.
If the level meter swings and "
1
the volume of the external device is too high.
Adjust the volume of the external device to the
"
" range, even if the volume is turned to the
maximum.
To reconfigure the line input settings, press
[MENU] and follow steps
After you finish adjusting the input/output level,
2
stop the sound source of the other device at the
position where you want to start recording.
10
Press [REC *] to start recording.
11
Play the external device.
*
Read the operating instructions for the connected device.
*
Disconnecting the audio cord during recording will
stop recording.
*
Change the line recording mode as necessary.
(➜ page 37)
*
The L folder will be automatically selected for
36
recording when line input sound is recorded.
36
Blinks
" is displayed,
4
6
to
.
This unit has the following synchro recording function.
This function detects the silence between tracks, etc.
and then records each track into different files, such as a
first track, second track, etc. If detecting sound from the
external device, recording starts automatically. If detecting
silence for approx. 2 seconds or more, recording is
paused. Detecting sound again will resume recording.
Synchro recording setting
• Press [STOP g/RETURN] to stop the unit.
1
Press [MENU].
2
Press +, – to select "LINE REC" and press
[q OK] to enter.
3
Press +, – to select "SYNCHRO REC" and
press [q OK] to enter.
4
Press +, – to select "ON
(Auto Stop)" or "ON
(Manual Stop)" and press
[q OK] to enter.
Auto: The recording pauses if approx. 2 seconds or
more of silence is detected and stops if silence
continues approx. 15 seconds or more.
Manual: Even if silence continues, the recording
continues to be paused (standby) until
[STOP g/RETURN] is pressed.
(The factory setting is "OFF".)
Publicidad
Tabla de contenido
