Maintenance And Repairs - Titan Control Max 1900 Pro Skid Instrucciones De Uso

Control Max 1900 Pro Skid

Maintenance and repairs

Before carrying out any work on the device, relieve the pressure and unplug the power plug from the socket.
Danger
a) Cleaning the inlet valve
If any problems occur when the paint is sucked up, the intake valve needs to be cleaned or replaced. Problems can
i
be avoided by cleaning and servicing the device properly.
1. Detach the suction hose from the basic unit.
2. Remove the inlet valve (Fig. 25, 1) from the base unit using a wrench (20 or Allen wrench 10mm).
3. Remove the valve seat (Fig. 25, 2), ball (3) and O-ring (4) from the inlet valve.
4. Clean the inlet valve mount and all components thoroughly with a suitable cleaning solution or replace them if necessary.
5. Lubricate the O-ring (Fig. 25, 5) on the inlet valve.
6. Place the valve seat, ball and O-ring back in the inlet valve.
7. Replace inlet valve assembly by screwing it into the sprayer.
b) Cleaning the outlet valve
If the spray pattern is poor, the outlet valve may need to be cleaned or replaced.
i
Problems can be avoided by cleaning and servicing the device properly.
1. Remove the high-pressure hose from the base unit using a wrench (17).
2. Loosen the screw (Allen wrench 2.5 mm) on the outlet valve (Fig. 26), but do not remove it.
3. Remove the outlet valve (Fig. 27, 1) from the base unit using a wrench (16).
4. Clean the outlet valve mount and the outlet valve thoroughly with a suitable cleaning solution or replace the outlet valve if
necessary.
5. Put the new or cleaned outlet valve back in.
6. Re-tighten the screw (Fig. 26).
Pos. Description
1 Spray gun assembly (incl. nozzle holder)
2 Nozzle holder
3 Sealing set
4 High-pressure hose, 15 m
5 HEA Filter Set (incl. ilter red and ilter white)
6 Door (1 pc.)
7 Carry handle
8 Suction hose and Return line
9 Clip (suction hose)
10 Clip (return line)
11 Return line
12 Clip (1 pc.)
13 Filter housing
14 Filter
15 Pressure gauge
16 Outlet valve
17 Repair kit for inlet valve
18 Inlet valve housing
Description
Nozzle 211 (20° spray angle, 0.011 inch nozzle diameter)
Nozzle 311 (30° spray angle, 0.011 inch nozzle diameter)
Nozzle 313 (30° spray angle, 0.013 inch nozzle diameter)
Nozzle 413 (40° spray angle, 0.013 inch nozzle diameter)
Spare Parts List (Fig. 28)
Accessories (not included in the delivery)
GB
Order No.
353-701
353-702
0517900
353-708
353-705
0580041B
0580175A
0580159A
9890222
0327226
0580487A
0512390
0580154
0580155
0580402A
0580072A
0580391
0580071A
Order No.
353-211
353-311
353-313
353-413
2 5