Stand-Alone Operation; Switching On/Reset; Setup - Futurelight AS - 200 Advertising Scan Manual Del Usuario

4.1 Switching on/Reset

After switching the Power-switch, the display shows the current time (after the first start-up, the display shows
00.00).
After pressing the Program-button or the Run-button, the motors are trimmed (Reset), the lamp is triggered and
the device is ready for use within approximately 20 seconds.
Caution: If the display shows „LAMP", the following errors may have occured:
-Lamp has not cooled down long enough (the projector will automatically start-up again after approximately 8
min.)
- After three more start-ups, the following errors may have occured:
Error 1:
- No lamp installed (please install the lamp)
- Lamp is too old or damaged. Please check the operating hour meter of the lamp (please replace the lamp)
Error 2:
- The photo-diode is broken (please let the device have repaired by a qualified technician)

4.2 Setup

Remark: You can also carry out the setup if the lampe is switched off.
On the left part of the control panel, you can adjust the following modes:
Press the Mode-button.
Select the desired mode via the Up/Down-buttons.
Adjusting the DMX starting-address:
This function is only needed for external control via a DMX-controller.
If several scanners are controlled via a DMX-controller, the starting address for each scanner has to be ad-
justed. The starting addresses for the individual scanners are:
Projector no.
Projector 1
Projector 2
Projector 3
Projector 4
Every projector occupies 11 or 8 control channels, respectively. Projectors with the same starting address will
work synchronically.
Press the Mode-button.
Press the Up-button until the display shows „DMXA".
Press the Enter-button.
Adjust the starting address via the Up/Down-buttons (0-512).
Press the Enter-button.

4. Stand-Alone Operation

DMXA DMX-starting address
TEST Test-program
RPAN Reverse PAN-movement
RTLT Reverse TILT-movement
SND Sound control
00.00 Adjusting the time/weekday
ONOF Adjusting the operating periods
POTI Operating-hour-meter
LATI Operating hours of the lamp
RETI Adjust the reset-intervals
PTRE Resolution PAN/TILT-movements
CHNG Inserting/exchanging slides
16-Bit-Mode
Control channels Starting-address
channels 1-11
channels 12-22
channels 23-33
channels 34-44
Control channels
1 channels 1-8
12 channels 9-16
23 channels 17-24
34 channels 25-32
24
8-Bit-Mode
Starting-address
1
9
17
25