Calling Up Programs; Writing Programs - Futurelight AS - 200 Advertising Scan Manual Del Usuario

Resolution of the PAN/TILT- movements
This function is only needed for external control via a DMX-controller. In the internal mode, the setting is always
16 bit.
In this mode, you can define whether you want to run the scanner in 8-bit-mode (8 control channels) or in 16-bit-
mode (11 control channels). The 16-bit-mode requires 11 DMX-channels and enables a higher resolution of the
mirror-movements.
Press the Mode-button.
Press the Up-button until the display shows „PTRE" .
Press the Enter-button. The display shows the current setting (8b or 16b)
Via the Up-button, you can change the setting to 8 or 16 bit, respectively.
Press the Enter-button.
Remark: In the 8-bit-mode, the last three control channels are not available.
Inserting / exchanging slides
Press the Mode-button.
Press the Up-button until the display shows „CHNG".
Press the Enter-button. The display shows „POS.1", which equals slide 1 of the slide-wheel.
Via the Up-button you can select the slides 2-5.
Remove the desired gobo/slide and insert the desired slide. Insert the slide with the white side downwards.
Caution: We urgently recommend to use the metal frames includes in the delivery, as these frames
protect the slide as heat shield from being transformed and worn-out. Make sure that you first insert the metal
frame and then the slide.
Remark: The fixation-rings and optional gobos can be found in the carton included in the delivery.

4.3 Calling up programs

Remark: All functions described in the following can also be carried out via the optional infrared remote-control.
The projector features 10 program memories. All preset programs are to be seen as suggestions how to program
the projector. These can always been modified and adjusted to your needs.
Calling up an individual program
Press the Program-button.
Select the desired program (1-10) via the Up-/Down-buttons.
Press the Enter-button. The selected program flashes on the display.
The projector runs through the selected program until you press the Program-button once more. The program
will then stop at the current step.
If you press the Mode-button, the projector will go into blackout and the light output is 0 %.

4.4 Writing programs

Your Advertising Scan features the possibility to edit the programs suggestions already installed. In this way, you
can individually adjust the settings and meet your requirements in a perfect way. A program is a sequence with
up to 99 steps, which have to be programmed one after another. A step is a projection defined by its individual
settings.
Via the Function-button, you can call up the different functions and program the settings.
Caution: Every change of the settings will immediately be stored and can only be undone by recalling the
manufacturer's program.
The slide-wheel features 5 empty slide-holders, which can be
equipped with slides. Furthermore, the static gobos can be
exchanged with the rotating ones of the slide-wheel. The service-
lid enables to exchange the slides easily during the operation.
Remark: Never use original slides, but rather copies. Make
sure that you use stable slide frames. The Advertising Scan
features special protection shields, which are to be inserted
between the lamp and the slides. In this way, the slide will not
become warmer than in a conventional slide projector.
Nevertheless, the slide may be transformed or the colours may
be modified due to long operational periods and excessive use of
the same slide.
Unsrew the two knurled-head srews on the service lid. Open the
service lid. The slide-wheel is located on the left bottom of the
section. Every slide can be positioned in front of the service lid via
the funcition „Change slides".
27